YH Soldering iron Adjustable temperature electric High-Power aluminum strong suction tin soldering gun welding tool set 60W | Инструменты

 

   

YH Soldering iron Adjustable temperature electric iron High-Power aluminum strong suction tin soldering gun welding tool set 60W

 

Soldering Iron Display

Our 908+ is light-weight,easy to carry and using.

 

60W ceramic heating element,double panel circuit board

 

We choose  the good quality double panel circuit board for you.

1.Stainless steel wire spring bottom connected,effective anti-static breakdown components, efficient and safe.

2.60W ceramic heating element, heating faster, precision used for most size solder joints.

3.Special metal protective clip, effectively prevent loosening of line pipe.

 

Temp. accurately&stable

 

In general,300~400℃ is our commonly operate range,and 200~300℃ is lower temperature area,over 400℃ is higher temperature area,we seldom use this.

High temp. silicon cord for soldering iron handle 

 

We provide high temp. silicon cord and  no any defected by high temperature.

 

10pcs high quality iron tip 

Suction gun performance characteristics:

* Made of steel pipe material, suitable for all kinds of tin removal work, strong tin absorption and high efficiency.

*Using a unique method of smashing the tin, it is easy to remove the tin swarf from the suction nozzle without clogging. * Lightweight design, easy-to-change nozzle, easy to carry, suitable for long time use, improve work efficiency.  Desoldering method   In the debugging, maintenance or welding error, etc., the components need to be replaced. When you replace components, you need to remove the solder. Due to improper welding methods, often   Causes damage to components, cracks in printed conductors, and even the detachment of pads. Especially when replacing an integrated circuit block, it becomes even more difficult.     1, using suction tin desoldering   The air pressure inside the solder sucker is first pulled out and jammed. The soldered joint is then heated to melt the solder. Then the suction nozzle of the solder sucker is aligned with the molten solder.   Click on the small bumps on the sniffer and the solder is drawn into the sniffer.   2, with tin soldering iron (electric suction tin) desoldering  Suction soldering iron is also a special desoldering soldering iron, which can inhale tin into the cavity while heating the solder joint, thus completing the desoldering. Desoldering is a detail  The work can not be sloppy, otherwise it will cause damage to the components and printed wire breakage and the loss of the pad caused by undue losses.     3, desoldering with solder strip (copper braided wire)  Take the rosin on the front end of the solder strip, place it on the solder joint that will be desoldered, and put the soldering iron on the solder paste to heat the solder joint. After the solder melts, it will be absorbed by the solder strip, such as solder joints. The solder has not been sucked once and can be repeated until it is completely absorbed. Cut off the part of the solder tape that has absorbed the solder.  

Production Capacity

 

At present, our factory have more than 10 production line,and almost reached production capacity: 14,000

pieces Per Month for rework station,35,000 pieces Per Month for soldering station and 115,000 pieces 

Per Month for electronic iron.