Stainless Steel Hydrothermal Autoclave Reactor with PTFE Liner Teflon Vessel Acid and Alkali Resistance10ml/20ml/25ml/50ml/100ml |

Stainless Steel Hydrothermal Autoclave Reactor with PTFE Liner Teflon Vessel Acid and Alkali Resistance10ml/20ml/25ml/50ml/100ml |

Features:

Hydrothermal synthesis reactor is used in catalysis, crystal, polymer and other experiments, it adopts the external heating mode, in order to reduce the size, and suitable for sevral reaction kettles working at the same time and same reaction temperature (for example, put sevral reactors inside the oven for heating), special models can be customized. Hydrothermal synthesis reactor, also known as digestion, pressure melting bombs, hydrothermal synthesis reactor, high temperature and pressure digestion vessels, PTFE high-pressure tank is in a certain temperature and pressure conditions, certain synthetic chemicals supplied reactor. It is widely used new materials, energy, environmental engineering and other fields of scientific research and experiments, is university teaching, scientific research units commonly used small reactors. [PARAMETER-1]--Maximum temperature: 200 degrees, Security temperature: 180 degrees, Maximum pressure: 3Mpa, Security pressure: 2Mpa [PARAMETER-2]--Heating, cooling rate: 5 c / min, Material: 304 stainless steel reactor, Liner: PTFE liner [ENSURE SAFETY]--PTFE lining can bear high temperature and high pressure, corrosion resistance, almost insoluble in all solvents, physical inert. [FEATURES]--High temperature resistance, Insulation resistance, Ultra corrosion resistanc, Anti-pollution, High lubrication [APPLICATION]--It is widely used in new materials, energy, environmental engineering and other fields of scientific research and experiments, is university teaching, scientific research units commonly used small reactors.

Methods of operation

The reaction means and the reactor body, and to ensure feeding coefficient is less than 0.8. When the Department of corrosive reaction when you want to put PTFE bush, can only be assured kettle body from corrosion. Hydrothermal synthesis reactor will be placed on the heater, in accordance with the provisions of the heating rate of heating to the desired reaction temperature (less than the required safety temperature). Completion of the reaction will be when its cool, but also in strict accordance with the provisions of the cooling rate operation, to facilitate the safety and reactor life. When confirmation of intra-abdominal temperature below the boiling point solvents reaction system can only open the tank lid after a follow-up operation. Hydrothermal synthesis reactor each time after use to clean, to avoid corrosion. Kettle body, kettle lid seal line to pay particular attention to clean and prevent damage to the bumps.