Pro Bomesh KL30 14.8g Spinning Guide Set 10ml Epoxy Resin NCP Thread Brush Measuring Cup DIY Custom Fishing Rod Accessory | Спорт и

Pro Bomesh KL30 14.8g Spinning Guide Set 10ml Epoxy Resin NCP Thread Brush Measuring Cup DIY Custom Fishing Rod Accessory | Спорт и

Pro Bomesh KL30 14.8g Spinning Guide Set 10ml Set Epoxy Resin NCP Thread Brush Measuring Cup Stick DIY Custom Fishing Rod Accessory

Combo 1 Contains:

1set KL30 Spinning Guide Set: KL 30# 1pcs, KL 20# 1pcs, KL 12# 1pcs, KT 10# 1pcs, KT 8# 1pcs, KT 6# 2pcs, MN Top Guide #6-2.2mm

1spool 50m NCP Black Color Wrapping Thread

Combo 2 Contains:

1set KL30 Spinning Guide Set: KL 30# 1pcs, KL 20# 1pcs, KL 12# 1pcs, KT 10# 1pcs, KT 8# 1pcs, KT 6# 2pcs, MN Top Guide #6-2.2mm

1spool 50m NCP Black Color Wrapping Thread

1set 10ml Set Epoxy Resin

1pcs Stick

1pcs Measuring Cup

1pcs Brush

Please mix A with B in 1:1 Ratio. If the temperature is too low and mixed epoxy is sticky, you could use lighter to heat it a little bit time and epoxy won't be sticky. Otherwise if you use it with sticky status, epoxy coating will be very thick on your rod. When you put epoxy resin on your rod blank, if there is bubble, you could use lighter to heat it very shortly and the bubble will disappear.

Generally it takes about 2-3 hours to get outter epoxy hard whiling rolling it on your drying machine when the room temperature is around 25 degree. And it takes about 12 hours to get inner epoxy hard. And when its inner epoxy become hard, you can feel the elastic of epoxy when you touch your rod. This is normal phenomenon.

If you want to use black epoxy resin, you could add some black ink into epoxy when you mix them.

Please note that if your epoxy is iced when you receive it, please don't worry about it. It's just very normal because of the cold weather during transportation. You could put epoxy bottle into a warm water with 40-50 degree and leave it for a while. Then your epoxy will become normal and you could use it directly.