Модуль для arduino LCD 1602 tft экран 16x2 ЖК-дисплей с подсветкой 5 В зеленый и белый код diy

Модуль для arduino LCD 1602 tft экран 16x2 ЖК-дисплей с подсветкой 5 В зеленый и белый код diy

 Capacitor

 Sensors

 Resistor

 Crystal

 EL Products

 LCD Display

 Integrated Circuit

 Transistor

 Diodes

 Thyristors

 Material

 Potentiometor

Pin interface specifications table

Numbers symbols pin pin that Numbers symbols that

Numbers

Symbols

Pin that

Numbers

Symbols

Pin that

1

VSS

To power

9

D2

Data

2

VDD

Power positive

10

D3

Data

3

VL

Liquid crystal display bias

11

D4

Data

4

RS

Data/command options

12

D5

Data

5

R/W

Read/write choice

13

D6

Data

6

E

By using the signal

14

D7

Data

7

D0

Data

15

BLA

Backlighting power positive

8

D1

Data

16

BLA

Backlighting power negative

Foot 1: for to power VSS.

Foot 2: VDD take 5 V is power.

Foot 3: VL for LCD contrast the adjustment, and then when the power is the weakest contrast, grounded contrast the highest, and the contrast .Through high can produce the "ghost", when used, can pass a 10 K adjust potentiometer contrast.

Foot 4: RS for registers choice, high electric usually choose data registers, low electric usually choose instruction register.

Foot 5: R/W signal lines for reading and writing, high electric usually are read operation, low electricity at ordinary times for write operation. When the RS and the R/W common For low electricity can be written instructions at ordinary times, or Display address, when RS for low level R/W high power for at ordinary times can read busy signal, and when RS for high level R/W for low electricity data can be written at ordinary times.

Foot 6: E end to make can end, when E is driven by high level jump into low electricity at ordinary times, LCD module executive order.

Foot 7 to 14 : D0 ~ D7 for eight two- - way data cables.

Foot 15: back light positive.

Foot 16: back light negative.

Features: LCD display module with blue backlight.

Wide viewing angle and high contrast.

Built-in industry standard HD44780 equivalent LCD controller.

Commonly used in: copiers, fax machines, laser printers, industrial test equipment, networking equipment such as routers and storage devices.

LCM type: Characters

Can display 2-lines X 16-characters.

Voltage: 5V DC.

Module dimension: 80mm x 35mm x 11mm.

Viewing area size: 64.5mm x 16mm