5-6V DC DSK900 Full Range RF Wireless Signal Detector Camera Bug Audio Voice Finder Cell Phone GPS Scanner Tracker 1MHz-6.5GHz |

DSK900 Full Range RF Wireless Signal Detector Camera Bug Audio Voice Finder Cell Phone GPS Scanner Tracker
Feature:
1. Detecting Pinhole Camera:
a. Press the switch button to turn on the detector, start flickering on the back of six lasers, and change the frequency of laser flickering once by holding for 2 seconds.
b. Turn on the switch to select the required flicker frequency, a total of eight levels, through the window to observe the surrounding environment, if the detection of pinhole camera lens will reflect and gather into a red dot.
2. Detecting Mobile Phone Signals:
a. In a place or an object, such as a car, where there is no signal or the wireless signal is weak, the detection can be started.
b. Turn the sensitivity switch to the maximum, when the strong vibration of the machine calls slowly reverse direction to reduce the sensitivity switch until the vibration stops. At this point, the sensitivity of the machine is the best initial test state in the field.
c. If a wireless signal is detected, the machine will vibrate or beep. When the signal becomes stronger and the indicator bar is fully lit, the antenna will be shortened gradually, and the sensitivity switch will be slowly reversely adjusted to reduce the frame measurement range. Finally, the transmitting signal source can be found.
3. Detection of Strong Magnetic Signal Source:
a. Magnetic suction locator, detectors are mostly used in automobiles, and concealed test placed strong magnetic probe detection distance within 5-10 centimeters.
b. It is suggested that in the car, under the car, or after opening the front and rear covers, the strong magnetic probe should be close to the area to be detected, and the strong magnetic adsorption equipment can be easily found by gridding the sub-area and close-range exploration.

Specification:
Colour: Black
Material: ABS
Detection frequency range: 1MHz-6.5GHz
Power supply: built-in 3.7V 400mAh lithium battery
Charging Voltage: 5-6V DC
Working current: 100mA
Use time: about 5 hours
Product weight: 61g
Packing weight: 200g
Product size: about 10*5.8*1.5cm/3.93*2.28*0.59''
Packaging size: about 14.5*9*5.3cm/5.7*3.54*2.08''
Plug type: US, EU

Note:
Please allow 1-3mm differs due to manual measurement.
Due to the different display and different light, the picture may not show the actual color of the item. Thanks for your understanding.


1 X Signal Detector
1 X Charger
1 X User Manual



[relateproductdetail/]