NEW for NOVOFERM NOVOTRON 504 MAX43-4 transmitter 433 92mhz Rolling code | Электроника

NEW for NOVOFERM NOVOTRON 504 MAX43-4 transmitter 433 92mhz Rolling code | Электроника

We know you have a world full of choices , thank you for selecting us !

Before order  

kindly note , our remote is the COMPATIBLE / REPLACEMENT /CLONE remote , not the original one  .

please make sure your remote / system  can be used before buying .

As a general guide, if the remote you currently use is one of the remotes pictured in the ad then this remote will be compatible with your motor.

if you are not so sure , please contact us without hesitate  .

 Compatibility

 NOVOFERM NOVOTRON 502 MAX43-2, NOVOFERM NOVOTRON 504 MAX43-4 433,92mhz Rolling code(Original remote show as the ad)

Programming instructions

 Programm it just like you would your original  NOVOFERM NOVOTRON 502 MAX43-2, NOVOFERM NOVOTRON 504 MAX43-4  remotes.

Novoferm remote programe

E41/43-U

1,Press the learning button on receiver until LED flashes,then hold button on transmitter  down for approx.3 seconds untill LED on receiver flashes rapidly.

2,Repeat this procedure for any further hand transmitters ,up to 60 transmitter codes can be taught in .( the receiver can compatible with 60pcs remotes)

3, If transmitter  has encoding switch ,not all switches should be in the same setting  ,the receiver will not accept this for safety reasons.

4, Deleting hand transmitter codes at  receiver :

Detail image