Для Honda Grom (MSX125), Monkey 125, Phantom 750 Все годы Мотоцикл Круиз-контроль на руле с блокировкой дроссельной заслонки.

Для Honda Grom (MSX125) Monkey 125 Phantom 750 Все годы Мотоцикл Круиз-контроль на руле с блокировкой дроссельной заслонки.

If you like other shippingments ,please tell me.

We will give you the details of the shipping you need.

Select product type:

Bottom kit:

You will need the bottom kit if: There is a heated clamp wire that protrudes from the upper half of the rubber clamp flange. There is no other interference. Most motorcycles will be able to use the bottom kit.

Top package:

You will need the top kit if the following conditions are met: The gap between the fuel tank and the throttle housing when turning fully to the right is less than 1.5 inches (38 mm). The lower half of the rubber grip flange has a heated grip cord.

Note:

If you don't know which type of product your motorcycle is suitable for, please contact our online customer service before submitting an order.

The chrome grip flange must be removed before mounting the Throttle Lock. Top Kit can be used after chrome grip flange is removed. Bottom Kit may interfere with use of indicator button on housing.

Friction Pads are required.

The GFYSHIP Throttle Lock was designed to be used with friction pads. Friction pads can last anywhere from 3,000 miles to 40,000+ miles. The wear depends on how often you rotate the throttle while it is engaged and if your throttle housings has sharp edges that rub on the friction pad.

Which friction pad should you use?

The friction pads come in 3 different thicknesses. Your kit comes with ONE of each size but you will only need to apply one pad to your Throttle Lock. You will want to start with the thickest friction pad and see if it fits between the throttle housing and the Throttle Lock Stopper Arm. If it doesn't fit, try the next size down until you find the right size that does not make contact with the throttle housing when disengaged.

Where should I place my friction pad?

We recommend sticking the friction pad along the top edge of the stop arm, however, for some motorcycles, this is not the best solution. If there are any bevels on your throttle housing that will interfere with the friction pad in any part of the rotation, then You need to adjust the position of the friction pad to avoid these slopes. Sometimes this means placing the friction pad a few millimeters from the top edge of the stop arm, or placing it on the far right or left side of the stop arm.

Furnish:

For Honda Grom (MSX125)   ALL Year
For Honda Monkey 125   ALL Year
For Honda Phantom 750   ALL Year

Bottom kit:
顶部套件: