25 Pcs Plastic Push in Car Bumper Fender Door Rivets Clip with Hood Release Latch Handle Repair Kit Fits for Honda | Автомобили и

25 Pcs Plastic Push in Car Bumper Fender Door Rivets Clip with Hood Release Latch Handle Repair Kit Fits for Honda | Автомобили и

25 Pcs Plastic Push in Car Bumper Fender Door Rivets Clip with Hood Release Latch Handle Repair Kit,Fits for Honda

2 set Auto parts: 1 set x Hood release Handle & 25 x Plastic Rivet
This fits all models of the for Honda Civic from 1996 to 2011, for Honda CR-V from 1997 to 2006, for Honda the Ridgeline from 2006 to 2014.
This replacement hood release latch is a repair for the plastic latch which will often crack and break off the end of the cable. This can be installed in 5 to 10 minutes.
This sale is NOT for the entire cable, just for the replacement latch handle that fits on the end of the cable.

Color: black;
Material: aluminum+Plastic
Plastic Rivet:
Product Name: Clips/Rivets/Fastener; Fit Hole Size: 10mm/0.4inch
Head Diameter(max.): 20mm/0.8inch; Stem Length: 17mm/0.6inch; Total Length: 26mm/1inch
Quantity: 25; Interchange Part Number: Under Engine Splash Guard Rivet Fastener Clips; Manufacturer Part Number: Plastic Push-Type Bumper Retainer Clip
Other Part Number: Screw Fender Body Door Trim Panel Hood; Applications: Defender Door Card Interior Weatherstrip Moulding;
Hood release Handle:
These rivet fasteners are made of plastic material, suitable for car use.
Car good accessory, commonly used for fitting side skirts, bumpers and other trim.
These clips are suitable for firmly holding anything within a fit diameter hole.
They can be used on buses, trains, planes, truck, caravans and car.
Machined from a solid block of aluminum.
The normal cable replacement would take between 1-1/2 and 2 hours. This replacement latch can be installed in a few minutes. It requires the removal of the corner plastic kick plate. Then about 1inch of the remaining plastic must be trimmed off the end of the cable with wire cutters. (See photo.) Slip it over the end of the cable, tighten the 2 set screws, replace the corner plastic kick plate, and you are finished.

Package Contents:
1 x Hood release Handle
1 x Hex key
1 set x screw
25 x Plastic Rivet

Only the above package content, other products are not included.
Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.