160W 7A 12V 24V Двухканальный модуль управления постоянным током двигателя L298 сигнал логического управления оптоизолятора PWM Привод торможения включен.

160W 7A 12V 24V Двухканальный модуль управления постоянным током двигателя L298 сигнал логического оптоизолятора PWM Привод торможения включен.

Unavailable in 

5,0

All stars

160W 7A 12V 24V Dual Channel DC Motor Driver Module L298 Logic Control Signal Optocoupler PWM Drive Motor Braking

Parameters: The power supply voltage is 6.5V-27V. The power supply cannot be connected reversely or exceed 27V, otherwise the module may be burned. It is recommended to connect a 15A fuse in series with the power input.

Dual motor interfaces, each with a rated output current of 7A and a peak current of 50A. The motor interfaces cannot be short-circuited. It is recommended to connect a 15A fuse in series. The enable signal and the forward and reverse control signal control the voltage 3-6.5V.

The signal terminal (ENA) inputs PWM speed regulation, the PWM frequency range is 0-10KHZ, and the minimum PWM pulse width is 10us.

Strong drive: The motor drive control adopts double H bridges, which can drive two DC motors at the same time.

CLOCKWISE and ANTICLOCKWISE ROTATE: IN1, IN2/IN3, IN4 ports can control the motor to rotate clockwise or counterclockwise.

Under-voltage protection: It has under-voltage protection function to prevent instantaneous high current from damaging the module.

Name: Double H-bridge motor controller 6.5-27V/7A

color: red

material: metal

Product size: 55x55x16mm

Mounting hole diameter: 3mm, please prevent short circuit on the reverse side of mounting, you can add insulating pads or copper pillars to raise the circuit board

Parameter matching:

Motors with rated voltage of 24V, rated power of 115W and below, and motors of rated current of 7A can work at full load for a long time.

Notes:

The drive power supply cannot be connected reversely. If overvoltage, the drive module may be burnt when the power is turned on.

It is recommended that the rated output current of the power supply is more than 2 times, so as to avoid the power supply voltage not reaching the input voltage required by the motor when starting, causing the drive module to suspend the undervoltage protection.

The motor interface cannot be short-circuited, otherwise the drive module may be burned. It is recommended to connect a 10A fuse in series with the motor interface.

Package includes:

1x DC motor control board

Note: Light shooting and different monitors may cause the color of the objects in the picture to be slightly different from the actual object. The allowable measurement error is +/- 1-3cm.