Плоский присосок промышленного пылесоса с ребрами механической насадки ZPT16CNJ/ZPT16CSJ10/20/30/40/50-04/06-A10. Прикрепленный вакуумный присосок ZPT16CNJ-06-A10.

Плоский присосок промышленного пылесоса с ребрами механической насадки ZPT16CNJ/ZPT16CSJ10/20/30/40/50-04/06-A10. Прикрепленный вакуумный ZPT16CNJ-06-A10.

Excellent antiaging properties, chemical resistance, electrical insulation properties. 

Excellent oil resistance, high abrasion resistance, good heat resistance, strong 

adhesion. Good water resistance, air tightness and excellent bonding properties. 

good elasticity and resistance to compression deformation etc.

How to Replace

Since pads are essentially rubber, deterioration is unavoidable. The rate of deterioration depends upon factors

such as conditions of use environment and temperature. Regular maintenance should be performed. If any damage,

splitting, cracking or abrasion has occurred in a pad which appears to be harmful, replace it immediately.

Also, take care not to damage the outside surface of the pad.

1.Pull the lock ring upward, and after lifting it to the adaptor, remove the old pad by pulling it downward.

2.While holding the lock ring in the raised position, place a new pad onto the adaptor.

3.Confirm that the pad is securely in place,and then return the lock ring to its original position.